Hello folks,
I need your help in following situation.
My source-system has 1 RAID5 (600GB) over 5 HDDs. On the RAID-Disk are one primary partition (250GB) and 1 extended partitions (350GB).
Because the hardware is out of support, I will migrate it to new hardware-server. I must minimized the downtime and the administrative effort. So I can't reinstall a new windows-installation, because 4 different software-licences are binding on SID. Additional a DFS-R is configured, so I need some hours to reconfigure it.
The new destination-system has one RAID1 (300GB) that I will use it for windows-system, and one RAID 6 (1TB) that is planed for data.
I has make a full backup (with all Critical) by using Windows Server Backup to a NAS storage. Than I has boot my destination system from Windows Server 2008 R2 media, and will make a recover. All Hard Disk is detected, after I install the storage-drivers. When
I confirm the last step in windows-server-backup, windows-backup stop with error "Not enough space on harddisk 0"
How can I move the extended partition to harddisk 1 (RAID6) durring BMR??? I cann't exclude the volume in backup-procedure, because the DFS-R is installed with some share on this disk.
Has anyone a idea?
Best regards